Engineers at the University of Edinburgh and tyre manufacturer Michelin have jointly developed flexible rotor blades for tidal-stream turbines that adapt automatically to changing water flow — potentially removing the need for the complex, expensive blade-pitch systems on conventional tidal turbines, according to a study published in Nature.
Tidal turbines endure severe material stress: turbulence, waves and reversing currents hammer the blades with high and fluctuating loads, leading to rapid fatigue, failures and costly repair work — repair underwater being especially difficult. To cope, tidal turbines normally include an electromechanical pitch system that feathers the blades out of the flow when currents are too strong, relieving the rotor.
The Edinburgh–Michelin approach replaces that mechanism. The blades are made of flexible rubber with a continuous steel core, inspired, the researchers say, by fish and trees that yield to water and wind by bending. The trailing edge flexes as flow speed rises, flattening the cambered profile and shedding excess load without electronic control or mechanical actuation.
The team tested a model turbine with a 1.26 metre rotor diameter in the university's FloWave facility — a 25 metre circular tank 2 metres deep with more than 168 wave generators and 28 flow drives, capable of producing waves and currents from many directions at 1:20 scale. Combining measurements with simulations of a full tidal cycle, they found the rubber-bladed turbine produced the same amount of energy as a comparable actively controlled system, while reducing the load fluctuations driven by changing flow. Because rubber has a density similar to water, the blades can be built to be neutrally buoyant, damping loads further.
The researchers have also simulated a tidal turbine with rubber blades at a 20 metre, market-standard rotor diameter; results suggest the approach scales. Preliminary calculations indicate the fatigue life of the rubber blades could substantially exceed the roughly 20 years typical of today's turbines. The team says the technique could allow lighter rotors and turbines at higher power, lower maintenance costs and cheaper energy, and could open sites where current energy is high but the turbulence was previously considered too extreme.
Caveats: the results so far come from a sub-scale model and simulation, not a grid-connected commercial installation. Michelin's involvement raises the obvious question of how rubber blade durability behaves after years of biofouling, UV and salt exposure — questions the researchers say require further testing before commercial deployment.



